goscrewyourselves
I'm the one
Agreed, just the best "normal primer" for plastic I can get. I might be old fashioned but I still believe preparation is 90% of the end result - more or less.
Wash with dishsoap, trim/sand imperfections and give it a spray and your good to go , same thing with the little pieces.
We were just making sure you were paying attention.
Ahh you talkin' to me????
Just about ya.
Is it a single auger stove or a double? I had to replace the motor of the lower auger a couple years ago. The top auger was trying to cram the pellets to the lower which wasn't taking them, just making dust. It was $150 or so including overnight shipping. We used a kerosene stove as a back up in the mean time.So far as the stove goes, well - our service guy turned up, heard the problem saw the auger motor running, the auger turning and pellets disappearing from the hopper - just not going into the burn pot. He shrugged, then did everything I did last night and I'll be buggered, the thing started dropping pellets again. The real issue now is that neither he nor I know why what happened occurred. From my perspective I have an unreliable pellet stove so a new one in is the near future, although not an immediate necessity.
This looks like a lot of good stuff. Does Bachmann's DCC engines run with any DCC command controls, or do they have their own DCC that you need?