North Bound
Bryan
I have an NCE PoweCab control. Just purchased two Kato SD40s at a show that had Digitrax DN163K1C Decoders installed. The seller said he had speed matched them but when I tested them in a consist (by not coupling them together), one engine was considerably faster than the other.
So my question is, how do I go about programming one of the engines to match the other? Looking at the NCE manual it isn't really clear to me. I am new to DCC so any advice would help.
Related to that, how close in speed is good enough? Do you ever get two engines to be equal? If not, do you stick the slightly slower engine in front or in back in a consist?
Thanks,
Bryan
So my question is, how do I go about programming one of the engines to match the other? Looking at the NCE manual it isn't really clear to me. I am new to DCC so any advice would help.
Related to that, how close in speed is good enough? Do you ever get two engines to be equal? If not, do you stick the slightly slower engine in front or in back in a consist?
Thanks,
Bryan