Trying to figure out the CV values and whatnot from the Tsunami "Setting the Hyperlight effects" section in their manual. As per usual lots of page flicking back and forth, trying to get my head around it. The TSU is a replacement for a Tsunami decoder for a "Bowser" loco that was made for LED only lighting, that had been used and was not very good. The TSU is not of course and the LED's I used (2 only, headlight and Mars) were Atlas ones. I used 1000 ohm resistors on the negative legs. The Mars light (F5) is plenty bright enough, but the headlight (F0) has never been bright, oddly enough, with either of the decoders. I'm sure I read somwhere that the brightness of the LED could be CV adjusted. F7 dims it slightly more and I notice, the Mars simultaneously. Can't find anything in the manuals section about adjusting the brightness. It does talk about an LED Compensation Mode, but stuffed if I can make sense of it. It seemed to indicate that 128 should be added to the CV controlling the H/light (CV49) which by a chart on the next page appeared to indicate a V of 0, default. No luck.
The other thing I want to do is have the Mars light working as well.
The other thing I want to do is have the Mars light working as well.