TrainController questions


fcwilt, you are now reading my mind.
I think the power supply is now doing what we had hoped it would.

Let's let it go until I can get a controller to work with.

I agree with you that the forum answer and question thing is a slow process.

When we start up again dialog over the phone would be preferred.

Thanks for all you help and patience.
I will drop you a note when I get a controller.
 
An update if anyone is following this thread.
All the problems are fixed.
All of the problems I was having were do to the fact I had no idea what I was doing.

Once you get to understand these Watchman they are really simple to setup.
Traincontroller is fairly easy to use if you read the manual.

Yes there is a learning curve to both. However, it is not that steep and there are people here to help.

Try it you will like it. ;)

Onward and upward to signals. HAHAHAHAHAAH
 
This is an old thread but I have questions about traincontroller. I am using digitrax BDL168 for occupancy sensors on the blocks. I do not want to use transponders. Here is the problem. When I put brake markers and stop markers on the blocks traincontroller stops communicating with the occupancy sensor. When I go to the connection drop down menu only the transponders are listed as an option. The BDL168 is no longer listed. I would like to use the BDL168 and not the transponders. What am I doing wrong?

I also have some short blocks and would like to mark them as critical. How do I do that? Thanks in advance for the help.
 
You must log in or register to reply here.



Back
Top