goscrewyourselves
I'm the one
So I have been redoing my little "Test Track Layout" and have about half of the trackwork down. That track work is powered by one set of feeders from an MRC 1370 DC Controller.
Anyway, thought I'd see how the trackwork looked and used one of my DC Kato engines as a test run. As soon as I turned the MRC on the engine powered up and took off like a bullet. It is either Go or Stop with no speed control in between? I then tried a couple of other DC engines and got the same issue - 100 MPH or dead stopped!
I have never experienced this before so am at a loss as to what is going on. Can anyone give me an idea of what the problem is please.
Anyway, thought I'd see how the trackwork looked and used one of my DC Kato engines as a test run. As soon as I turned the MRC on the engine powered up and took off like a bullet. It is either Go or Stop with no speed control in between? I then tried a couple of other DC engines and got the same issue - 100 MPH or dead stopped!
I have never experienced this before so am at a loss as to what is going on. Can anyone give me an idea of what the problem is please.