TLOC
Well-Known Member
Still working on 8-20’ containers, 2 of the 53’ and 2 of the 40’. 12 of 24 total containers needed and may still need more work. The Tamiya X-21 flat base, I must have put lots more then the 5% I like to add. The talc is sure showing and on these 12 would not brush out. The additional fade coat also didn’t help as much as it did on the other 12.
Next up for these 12 is rusting at each locking point and streaking it faintly down the container sides. Some splatter on the front panel and rear doors and hopefully I like it.
These 10 are barely faded and have a matte clear finish, Army Painters “air” clear thinned 50/50 with warm tap water. The client had approved them and his daughter was here this morning and picked them up
There are 2 more 53’ containers that I replaced with 2 of my own that were the same contain name. These 2 will be stripped and the process started over
Next up for these 12 is rusting at each locking point and streaking it faintly down the container sides. Some splatter on the front panel and rear doors and hopefully I like it.
These 10 are barely faded and have a matte clear finish, Army Painters “air” clear thinned 50/50 with warm tap water. The client had approved them and his daughter was here this morning and picked them up
There are 2 more 53’ containers that I replaced with 2 of my own that were the same contain name. These 2 will be stripped and the process started over