oplholik
Member
I am trying to get my DSC up and running and today I wanted to get the new Kato DCC loco going. I cleaned the track on my test board, connected it to the dcs, A track wire to A track connection, and the same for B track. With the loco on the track I wanted to find out which address was in the decoder. All I could get was an error(d nd) which means an open circuit on the track. So something is not right, and I really don't know where to go from here. Help! I did look in the manual and one of the problems could be decoder not installed properly. I don't mind taking the cover off the engine to look at it, but it's not like I'd know if the decoder is installed properly or not. Maybe there are easier things to check and try first? Thanks.