Building the Walthers N Scale Coke Oven & Quencher ~~ Start to Finish

[Trucklover]

Here is part 2 of the series, the Walthers Cornerstone Series Coke Oven & Quencher Plant

Here is a pic of the Walthers Coke Oven from Walthers web site

 

[Trucklover]

Step 1

I assembled the "foundation" and the footprint of the layout of the Coke Oven & Quencher Plant

 

[Trucklover]

Step 2

I painted the Lower Oven Walls a primer grey and then glued them in place

 

[Trucklover]

Step 3

These one's are of the 2 Coal Bunker Supports. I sprayed them a rust color with the brick walls sprayed primer grey.

 

[Trucklover]

Step 4

Here is the Outer End Wall for the Lower Coal Bunker Section. It has some access doors. The Brick Wall was also sprayed Primer Grey with the Roll-up Door and Personel Door begin sprayed a lighter grey.

Here is the Lower Coal Bunker Assembly. The Coal Bunker will sit ontop of the supports at the top

 

[Trucklover]

Step 5

Glued the Lower Coal Bunker Assembly to the Foundation of the Ovens

Glued the Oven Floor in place. This floor will be very weathered

 

[Trucklover]

Step 6

The Coke Oven Walls have been sprayed a rust color while the Brick Oven Walls were sprayed the grey primer color.

Oven Top has been sprayed a tan color and glued in place ontop of the oven walls. The Oven Top will be weathered with bits of brown, black, orange, and red colors and the walls will be weathered the same way.

 

[Trucklover]

Step 7

The rest of the Oven Top has been glued in place.

 

[Trucklover]

Step 8

Here is the top portion of the Coal Bunker which has been sprayed the rust color. The black part is where it will be sprayed an aluminum color as it is aluminum siding.

Aluminum Siding sprayed.

Added the roofs to the Coal Bunker. The opening is for the conveyor that will come from the Crushing House.

 

[Trucklover]

Step 9

Supports for the Stairwell that will come from ground leveel up to the Oven Top.

 

[Trucklover]

Step 10

Here is the stairwell that goes from the ground up to the top of the ovens. This is the unpainted pic.

Here is the painted Stairwell. I sprayed it a bright safety yellow which will be weathered to look used.

 

[Trucklover]

Step 11

Collector Pipe has been glued to the Ovens top and into the Governor House.

 

[Trucklover]

Step 12

Oven Staircase glued in position

 

[Trucklover]

Step 13

Governor House has been built and sprayed several diff colors including Rust color for the support structure, Silver for the aluminum sheeting walls, and grey for the door to the Governor House

Governor House Rear. You can see the Collector Pipe going in the Governor House.

 

[Trucklover]

Step 14

Governor House Staircase.

 

[Trucklover]

Step 15

Smokestack. It has been sprayed grey and will be weathered with brown, black and rust chalks

 

[Trucklover]

Step 16

Lower Crusher House Walls. They have been sprayed an aluminum color. That is an access door were the hole is and on the other side is where the conveyor goes out from to go to the top of the Coal Bunker

 

[Trucklover]

Step 17

Crusher House. Been sprayed Rust Primer and aluminum on the top just like the Coal Bunker

 

[Trucklover]

Step 18

Added the side Roofs to the Crusher House

 

[Trucklover]

Step 19

Added the Side Walls for the Conveyor to go in