WC3026
Member
Ok So I am trying to switch over all my Athearn Locos over to LED lights. I am starting with my one and only RTR unit. I took the wires from the blubs off of the board and took led with resistor and touched to the board and have nothing. took resistor off and still nothing. I out the bulbs back on and they light up.
What I am using for LED's are Miniatronics Tower LED's 2mm the resistor is a 470 ohm. It says 3 volts is recommended. I took the led right to the track with the resistor and it lit up and was nice and bright.
I am using Digitrax DH123 decoders. Is there something I am not doing right for it
What I am using for LED's are Miniatronics Tower LED's 2mm the resistor is a 470 ohm. It says 3 volts is recommended. I took the led right to the track with the resistor and it lit up and was nice and bright.
I am using Digitrax DH123 decoders. Is there something I am not doing right for it