Track Clearance ?


S

Smitty49

Member
I'm in the process of designing my layout and at a quandary as to clearance issues such as between parallel tracks and tracks that curve next to a vertical mountain wall .
Is there a standard that is used for track and/or car clearance at the sides and height and is there a gauge that can be used to check these clearances.
I'm also looking for a steam era trestle bridge to span 14" to 18" .
Any advise in these areas would be much appreciated,
Smitty
 
The center to center of tracks is limited to the radius of the curves that the tracks follow. I like to keep HO tracks a minimum of 4" apart (center to center)
If you use 22" radius 4" apart in a curve might be to close but on a 36" you will be fine
.increase the radius and you can bring parallel tracks closer.
the over hang of a long freight car will also limit what can be place near the tracks. It is a good idea at Stations, tunnel entrances and bridges to have atleast a 12" straight section before the tracks pass near any of these. this will help reduce the cars from catching them

Trent
 
You must log in or register to reply here.



Back
Top