Scordicus
Member
I have a Power cab and have recently started installing sound decoders in to my small fleet however I don't particularly like the way the sound stops dead as soon as the controller is set to zero speed, so I have selected to have the engine sound run on when the control speed is set to zero, on tick over until the loco is deselected. However, even after scouring the manual from front to back & the web, I can't for the life of me figure out how to deselect a loco..
Is there a way of doing this through the controller? As I don't particularly want to overload the system and have it trip out every few minutes if I have a few loco's fired up at the same time if they've been previously selected or have to limit the amount of sound fitted loco's I have sitting on the layout..
Upgrading with a booster is not an option as I don't have a particularly large layout so one is not needed & I don't intend having any more than two loco's running at any one time, I just need to kill the loco's that I no longer require to run at any particular time..
Any help would be appreciated...
Is there a way of doing this through the controller? As I don't particularly want to overload the system and have it trip out every few minutes if I have a few loco's fired up at the same time if they've been previously selected or have to limit the amount of sound fitted loco's I have sitting on the layout..
Upgrading with a booster is not an option as I don't have a particularly large layout so one is not needed & I don't intend having any more than two loco's running at any one time, I just need to kill the loco's that I no longer require to run at any particular time..
Any help would be appreciated...