Dave S
Tree Farmer
I picked up an F3 A/B set from Bowser the other day and installed the recommended decoders (LokPilot 4.0 p#546150). For some reason at the highest speed setting both units run like the throttle was set to half speed. At half speed setting they barely move and if i add some rolling stock they don't move at all, like they had no torque. My other locos, including several Bowsers, work just fine. It's only these two that are having the problem.
So far I haven't been able to figure out what is wrong. Anyone have some ideas?
So far I haven't been able to figure out what is wrong. Anyone have some ideas?