I'm using Peco Insulfrog turnouts. I like the way the points throw, the stability and the tie plate detail. But there are some drawbacks. One drawback is that the point, closure and wing rails are powered by the points making contact with the stock rails. This could be a problem because it relies on the points making good mechanical contact on clean rail, if the rails get dirty, there may be no power.
I've noticed that the Insulfrog turnouts have ties cut back beneath the turnout which would allow you to easily jumper the stock rails to the inner rails of the turnout. Is it OK to jumper these rails? I see a couple of potential short zones: where the closure rails meet the insulated frog, and where the insulated frog meets the frog rails.
Anyone jumper their Inulfrogs? Any problems?