Can someone please advise me on an alternative detection method.
I am using reed switches mounted between the rails to change turnout position and reverse center section polarity on a point-to-point track. Reverse loops at each end.
The reed switches are passing 5vdc.
I must use engines that are equipped with a magnet. Also if the engine stalls near the reed, the Atlas switch machines get a constant current and melt down.
So, another design would work with any piece of equipment passing a certain point. And would result in only a momentary contact. Thanks in advance for any help.
I am using reed switches mounted between the rails to change turnout position and reverse center section polarity on a point-to-point track. Reverse loops at each end.
The reed switches are passing 5vdc.
I must use engines that are equipped with a magnet. Also if the engine stalls near the reed, the Atlas switch machines get a constant current and melt down.
So, another design would work with any piece of equipment passing a certain point. And would result in only a momentary contact. Thanks in advance for any help.