siderod
Member
I have in my possession a first generation QSI sound decoder without an upgrade chip that I would like to use as a stationary decoder mounted underneath the table and used for background sounds. My question is, does anybody know if I need to put a load, like a resistor across the motor leads on the board since there will not be a motor attached? The throttle will be ramped up and down occasionally. My intuition tells me no but, I'd rather find out from somebody with some expertise in this arena rather than risk turning my decoder into an effective but short lived smoke generator in the event I'm wrong.
Thanks in advance for any help, advice, thoughts, suggestions and/or prayers on the subject.
Thanks in advance for any help, advice, thoughts, suggestions and/or prayers on the subject.