Rocky Lines
Member
I have seen many wiring schematics (sp?) (pictures) for how to wire Peco switches to their table top switch motor. They are very different from the old Tyco, model power or atlas switches. I have been told that I can use an Atlas switch control box #56 to control the Peco table top switche motors. The only problem is that I can not visulize what this wiring will look like. I have a power source, a CDU and the atlas switch control box #56 and the Atlas snap relay #200 and the Peco Table top switch motors for my peco switches. Can someone out there draw me a wiring diagram?
I will be using the Atlas snap relay #200 to control red and green LEDs on the so called control panel and for lights at the switch on the layout. The reason I want to use the Atlas switch control box #56, is so all of my switches are controlled the same way as I already have a good number of them installed and in use.
Thanks for any assistance.
I will be using the Atlas snap relay #200 to control red and green LEDs on the so called control panel and for lights at the switch on the layout. The reason I want to use the Atlas switch control box #56, is so all of my switches are controlled the same way as I already have a good number of them installed and in use.
Thanks for any assistance.
