Today I finished wiring my TMCC system into my one loop of track on my 8 by 8 table. Everything seems to be in working order. I have two conventional engines, one of which is at the shop, the other which hasn't ran in about 2 years. With the Power Master, I followed the instructions to make my engine run, but I was only successful in making it light up.
Here are the steps I took:
Turned on System
TR Button
1 Button
AUX1 Button
0 Button
Boost Button
Direction Button
The engine then went through the sequence of directions, but it showed no effort to move. Is it the engine, or the TMCC?
Here are the steps I took:
Turned on System
TR Button
1 Button
AUX1 Button
0 Button
Boost Button
Direction Button
The engine then went through the sequence of directions, but it showed no effort to move. Is it the engine, or the TMCC?