RockIslandModeler
New Member
I'm modeling in HO, have a forward facing helper unit in a two unit consist. Would like to know just how to write CV's in English for the rear lights ( and keep front off all the time ).
Not worried about the lead unit for it is an F7A with no rear light installed.
Below is page 46 from the "Quantum DCC Reference Manual" showing how to do it using "Bits". Bits and I do not get along very well so how do you do it using a "Zephyr" as like CV 49= ??, CV 55 = ?? ( or whatever as long as the bits don't bite me )
Below in the Reference page between the two "Fingers pointing" is what I need to make my P2K GP7 QSI unit behave with NO lights forward and reverse light in reverse only. ( sometimes if switching I like to see where I'm going. )
I know I can ( by default ) dial up engine ID # and press "0", but then no lights work either way period. Then when power is back on your back to square one.
OK need a guru here please.
Not worried about the lead unit for it is an F7A with no rear light installed.
Below is page 46 from the "Quantum DCC Reference Manual" showing how to do it using "Bits". Bits and I do not get along very well so how do you do it using a "Zephyr" as like CV 49= ??, CV 55 = ?? ( or whatever as long as the bits don't bite me )
Below in the Reference page between the two "Fingers pointing" is what I need to make my P2K GP7 QSI unit behave with NO lights forward and reverse light in reverse only. ( sometimes if switching I like to see where I'm going. )
I know I can ( by default ) dial up engine ID # and press "0", but then no lights work either way period. Then when power is back on your back to square one.
OK need a guru here please.