Search results


  1. G

    Train stopping on far side of track!!!

    Also, should I get a better transformer than the basic one that comes with the Atlas Trainman set?
  2. G

    Train stopping on far side of track!!!

    Here is a pic from my iPhone. The layout is about 48" X 60". That's just the track. The platform has an inch or more on the ends between the track and the edge.
  3. G

    Train stopping on far side of track!!!

    I am new to model railroading. I have an HO scale track. It has a loop within an outer loop, both are connected. The outer loop goes into a bridge and continues through the inner loop, which then crosses under the bridge to continue on the outer loop once again. The inner loop has about 19...
  4. G

    Question about radius

    HO scale and the maker of the locomotives is Athearn
  5. G

    Question about radius

    What is the smallest radius curve that an SD60 can run on? What about an SD40-2?
  6. G

    Soldering Track???

    Should I leave the rail joiners in place and solder right over them? I am currently using a small butane torch with a removable tip? Good or Bad? Should the track be laying flat while soldering or up on it's edge so that the outside of the track is facing up?



Back
Top