Could someone help me connect BDL168?
I have NCE Power Cab and LocoNet with PR3 -DS64-DS64.
The layout controls under JMRI.
The new BDL168 was installed without problems by the scheme "for non Digitrax Layouts".
When I tried to add the BDL168 to the LocoNet PR3-DS64 (without Digitrax...
Hello!
I couldn’t sent command from NCE Power Cab to Digitrax DS64 through SIC24AD.
(I used this SIC24AD with setup 1 without any problem already)
SIC24AD - with chip version #13.
Connect power from track to the “Track Power”.
IDC Input and IDC Outputs are empty.
Earth (5th pin from...
Hi!
I see that the posts are old, but today I have questions of NCE D14SR decoder.
I couldn’t to do that:
- light in the loco cabin switch off after some seconds when the loco begin to move.
- headlight is dim when loco is stop and bright when loco begin to move.
I couldn’t understand or I...
Dear friends!
I use standard table speed as default tor Walters Proto 2000 EMD f3A
And by NCE Power Cab I can see parameters: CV2 = 007, CV5=001, CV6 – could not read.
Why CV2 > CV5 ?
I need to adjust speed EMD f3 with others.