oplholik
Member
Saturday I bought a DCC system and a decoder for my Athern SD75M N scale loco. I first set up the Digitrax Zephr to run the loco DC, and it ran good. Then I took the shell off and pulled the DC decoder off in prep for installing the DCC decoder. To make this a little shorter, without installing the DCC decoder I reinstalled the DC, put the shell back on, set the loco on the track and tried to run it, it wouldn't move. The control is still set for dc. Then I noticed that there was one of the large pins that I use to hold track down laying across both tracks, how it got there is beyond me, but I'm wondering if that would have done something to the motor. The lights on the decoder still light up, but that's it. I can't see what else it might be. Thanks.
Paul
Paul